Electricity Forum Electricity Today Magazine Arc Flash Training

News and Trends

Latest News From The Industry

NOMEX protective garment

Advanced protection against electromagnetic exposures and electric arc

HAZARDS AROUND

While working live in the energized grid, presence of voltage around the workers requires special attention. However, live-line (live working) techniques are widely applied for decades, several accidents in the past prove that the level of safety must be improved to minimize the number and seriousness of injuries in the future.
In the high voltage grid, bare-hand method is a common technique for safe live work. In the surroundings of any energized equipment,...

Buyer's Guide


News & Trends


2024 CE Code Training - Better Understanding of the Rules

CE Code training is intended to do a lot more than instruct about what changes have taken place since the last time Canada issued a national electrical code. We are producing a series of courses across Canada by one of Canada’s leading experts on the 2024 Edition of Canada’s Electrical...

Counterfeiting Kills

Each year, the counterfeiting of well-known brands and products continues to rise, creating an even more threatening problem. Such well-known counterfeited brands, including consumer safety and critical electrical products, are estimated to be five to seven percent of world trade. The International...

Electrical Safety

CSA Z462 and CSA Z463: A Powerful Combination

I recently viewed a destroyed 600-volt electrical panel board that had exploded when an operator reset an 800-ampere (A) breaker. His leather-palmed gloves had synthetic backs that ignited and seriously burned the back of his hands. His flame-resistant (FR) shirt was untucked and he was burned on his right side.

It is unfortunate that he was not following Canadian Standards Association’s CSA Z462 standard: “Workplace Electrical Safety” clause 4.3.7.3.10 (d). It is incredibly fortunate that his employer provided arc-rated clothing, as only a few years ago, he would have been wearing cotton coveralls.

Consequently, this incident would have resulted...

The Guide to Arc Flash Clothing

A new method to choosing personal protective equipment

BY JIM WHITE, Shermco Industries, Inc.

Table 130.7(C)(15)(a) in the 2012 edition of NFPA 70E: “Standard for Electrical Safety in the Workplace”, published by the National Fire Protection Association, has always been difficult for technicians and safety professionals to use in the field. Even though it has an outstanding record since being introduced in the 2000 edition of NFPA 70E, some members of the technical committee have been solidly against it.

One of those committee members stated that if the tables were eliminated, everyone would be forced to have an incident...

Popular Electrical Safety Articles


Arc Flash Safety for Data Centers

15 arc flash mitigation strategies for the data center BY DAVID G. LOUCKS, Eaton Corporation Arc flashes—the fiery explosions that can result from short circuits in high-power electrical devices—kill hundreds of workers in the U.S. every year and permanently injure thousands more. They can also...

IEEE Method Vs. the NFPA 70E Tables

IEEE Method Vs. the NFPA 70E Tables: Evaluating arc flash analysis methods BY REZA TAJALI, Schneider Electric Recent changes in workplace safety regulations have heightened the awareness of hazards associated with electrical arcs. The hazard level must be quantified and workers properly protected...

Calculating Incident Energy

Over the last few decades, arc-fl ash hazards have been a significant concern for many electrical workers and employers. Many methods have been developed through the years to assess incident energy.The most common is that of the IEEE 1584, Guide for Performing Arc-Flash Hazard Calculations. These...

Frequently Asked Questions about Arc Flash Relays

Answering frequently asked questions about arc flash relays BY BOB ZWEIFEL, Littelfuse The dangers of an arc flash incident—burns, blast, molten metal ejected at ballistic speeds—are by now familiar to every electrical worker. Most electrical professionals have read about strategies to minimize...